1、车行通道由于车行频繁，相对于停车区，设计要加强，可采用 1-3 mm环氧地坪或2-3mm环氧自流平地坪，颜色通常为绿色，车行通道宽度根据现场情况设置，通常双向行车道不宜低于6米，单向行车道不宜低于3米，人行通道为1.5-2米，通道两侧划中黄色标志线，线宽8-12mm。

1. Because of frequent traffic, the design of vehicle lane should be strengthened relative to parking area. 1-3 mm epoxy floor or 2-3 mm epoxy self-leveling floor can be used. The color is usually green. The width of vehicle lane should be set according to the scene. Usually the two-way lane should not be less than 6 meters, the one-way lane should not be less than 3 meters, and the pedestrian lane should be 1.5-2 meters. Meters, the sides of the channel are marked with yellow markings, and the width is 8-12mm. 2、停车区对于平整地面,可采用0.5mm普通环氧地坪，而平整度及表面强度较差的地面，可以采用1-3 mm环氧砂浆环氧地坪，高级要求可采用2-3mm环氧自流平地坪；颜色可设计成灰色。

2. The parking area can adopt 0.5 mm ordinary epoxy floor for flat ground, while the ground with poor smoothness and surface strength can adopt 1-3 mm epoxy mortar floor, 2-3 mm epoxy self-leveling floor for advanced requirements, and the color can be designed to be grey.

3、车行通道标志内可采用黄色或白色标志漆（可采用夜发花环氧地坪漆）画箭头进行标明车行方向及指向各停车区，如A停车区、B停车区及C停车区等。

3. Yellow or white marking paint (night-blooming flooring paint) can be used to mark the direction of traffic and point to parking areas, such as A parking area, B parking area and C parking area.

4、柱面处理为增加停车场柱面的醒目性，避免因倒车碰到柱子，柱子下端1.0-1.2米以下可采用黄色和白色相间斜纹斑马线进行标明。

4. In order to increase the visibility of the parking lot column and avoid encountering the column due to reversing, yellow and white twill zebra lines can be used to mark the lower end of the column below 1.0-1.2 meters.

5、停车位设置按停车场地面区域结构设置停车位，小轿车通常可设计为2.5-3.0米X5-6米，停车位采用黄色或白色标志线画出，标线宽8-12mm。

5. Parking spaces should be set up according to the structure of parking ground area. Cars can usually be designed to be 2.5-3.0 meters X5-6 meters. The parking spaces should be marked with yellow or white markings with a width of 8-12 mm.

6、车辆出入口坡道防滑地坪车辆出入品必须具有防滑作用，有的停车场土建施工时已考虑到了，将之施工成波纹形不平的地面，这种情况下只需一部分涂车行通道颜色，一部分涂另一颜色，两种颜色相间就可以了。如果土建时未设计考虑防滑要求，在地坪施工明此处应采用防滑地坪，而且防滑骨料颗径应较大，通常直径不低于2mm，视坡道倾斜度而选择合适颗径的防滑骨料。

6. Vehicle entry and exit ramp anti-skid floor. Vehicle entry and exit products must have anti-skid effect. Some parking lots have been taken into account in civil construction. They are constructed into corrugated and uneven ground. In this case, only one part of the road color is painted, and the other part is painted with another color, so that the two colors can be alternated. If the anti-skid requirement is not considered in civil construction, the anti-skid floor should be adopted here, and the particle diameter of the anti-skid aggregate should be larger, usually no less than 2 mm. The appropriate particle diameter of the anti-skid aggregate should be selected according to the slope inclination.

7、车位编号车位应编号，编号按区域划分可依次分为C01-CXX，B01-BXX，A01-AXX，其中不吉利的号码可略去（如4、13等），编号字体可采用中黄色或白色，字体大小格式可为黑体1000-1200号字比较合适

7. Parking spaces should be numbered. Numbers can be divided into C01-CXX, B01-BXX, A01-AXX according to the region. Unfortunate numbers can be omitted (e.g. 4, 13, etc.). Number fonts can be in medium yellow or white, and font size format can be in bold type 1000-1200.

8、墙裙处理墙裙涂以和墙面及地面不一样的颜色，可在车行时起到提醒的作用。但不宜过高，一般0.2-0.7米即可。采用深绿色和淡灰色相间进行标志。

8. Wall skirt treatment wall skirt painted with different colors from wall and ground, can play a reminder role in driving. But not too high, generally 0.2-0.7 meters. Mark with dark green and light grey.

地下停车场环氧地坪涂装工程和施工方案

（1）环氧树脂砂浆　　

特点：A、抗压、抗冲、寿命持久

B、适合重载区域使用

C、耐多种化学药品有多种棉层结构可选，适用面广

D、机械施工，平整密实

说明：环氧树脂砂浆使用周期长，不易破损。具有抗压、承重、耐磨等优点，在烟草行业中应用广泛。

适用：机械加工厂、重载区域仓库、高级停车库、食品加工厂

（2）涂装式地坪　　

特点：A、可承载中等的荷载

B、有效防止水泥起尘　

C、耐磨、抗冲　

D、彩色外观，具有装饰性

E、造价经济

说明：涂装式地坪施工周期短，洁净无尘，造价经济，色彩多样，适合中轻型荷载的厂房使用。

适用：机械制造工厂、车间、仓库/造

（3）环氧树脂自流平

特点：A、微透气之结构，不惧地下潮气

B、完全水基系统，无任何环境损害

C、涂层抗压耐磨，适合中等载荷

说明：环氧树脂自流平是一种高强度、耐磨损、美观的地坪，具有无接缝、质地坚实、耐药品性佳、防腐、防尘、保养方便、维护费用低廉等优点。

适用：潮湿混凝土基面，无防水层的一楼地面，及其它有环保要求的场合。